Difference between revisions of "Equipment/Britannia Lathe"
Jump to navigation
Jump to search
m |
|||
| Line 14: | Line 14: | ||
| origin = Donation<!-- If via pledge, please link to the completed pledge page on the wiki --> | | origin = Donation<!-- If via pledge, please link to the completed pledge page on the wiki --> | ||
| location = <!-- Floor, room/zone and location within that area --> | | location = <!-- Floor, room/zone and location within that area --> | ||
| − | | maintainers = <!-- NO LINKS PLEASE; it currently breaks the template. If someone is nominated as managing the upkeep of this item, please list them here. --> | + | | maintainers = Oliver <!-- NO LINKS PLEASE; it currently breaks the template. If someone is nominated as managing the upkeep of this item, please list them here. --> |
| template_ver = 1.1 <!-- Please do not change. Used for tracking out-of-date templates --> | | template_ver = 1.1 <!-- Please do not change. Used for tracking out-of-date templates --> | ||
}} | }} | ||
| Line 22: | Line 22: | ||
There is a potential 12VDC in my box, will need to make a speed controller for it. Alternatively just use a normal mains motor with a step pully as the lathe was designed for. 3 phase motors with inverter speed controllers start to look expensive. | There is a potential 12VDC in my box, will need to make a speed controller for it. Alternatively just use a normal mains motor with a step pully as the lathe was designed for. 3 phase motors with inverter speed controllers start to look expensive. | ||
| + | -Oliver | ||
Revision as of 23:08, 29 May 2013
| Britannia lathe | |
|---|---|
 | |
| Model | Unknown |
| Sub-category | Metalworking |
| Status | Out of order |
| Consumables | Unknown |
| Accessories | Unknown |
| Training requirement | Yes |
| Training link | Unknown |
| Owner | Unknown |
| Origin | Donation |
| Maintainers | Oliver |
Britannia lathe renovation
27/5/2013 Removed tool board from back board. it's stored under/behind the lathe cabinet. Cut bit of wood for the motor to sit on. it's sitting in place for now with a sign not to remove. Will fasten it in place permanently when final motor decision is made.
There is a potential 12VDC in my box, will need to make a speed controller for it. Alternatively just use a normal mains motor with a step pully as the lathe was designed for. 3 phase motors with inverter speed controllers start to look expensive. -Oliver