Difference between revisions of "Equipment/DrillPress"
Jump to navigation
Jump to search
(add info about chuck) |
(formating) |
||
| Line 25: | Line 25: | ||
==Log== | ==Log== | ||
| − | <lovelace_> The chuck for the new stand drill falls out easily | + | #<lovelace_> The chuck for the new stand drill falls out easily |
| − | <lovelace_> I can't see how it tightens up | + | #<lovelace_> I can't see how it tightens up |
| − | <artag> it should be a taper. Assuming it's clean (not got anticorrosion varnish on it) then it should want a good fast whack up into the quill. Not with a hammer - just push it fast, by hand. Use the momentmum of the chuck to get it in hard. | + | #<artag> it should be a taper. Assuming it's clean (not got anticorrosion varnish on it) then it should want a good fast whack up into the quill. Not with a hammer - just push it fast, by hand. Use the momentmum of the chuck to get it in hard. |
| − | <artag> if there's a screw thread in the end of the taper thrn it can use a drawbar like the 3-in-1 but that's fairly unlikely | + | #<artag> if there's a screw thread in the end of the taper thrn it can use a drawbar like the 3-in-1 but that's fairly unlikely |
| − | <creature> Your mum enjoys a good fast whack up into the quill. | + | #<creature> Your mum enjoys a good fast whack up into the quill. |
| − | <lovelace_> K, seems firmly in now | + | #<lovelace_> K, seems firmly in now |
| − | <Randomskk> that's what she said | + | #<Randomskk> that's what she said |
Revision as of 12:09, 13 May 2011
Status
We now have a drill press. The keyless chuck only goes down to 2.7 mm, so we need to get a "pin chuck".
Or use the Dremel and mini-mill for high speed / light duty / precision stuff, this one for everything else.
Ideal jobs :
Dremel
- High speed, tiny bits e.g. PCB drilling
Mini-Mill
- Milling plastic, small aluminium etc.
- Drilling jobs requiring accurate positioning - use the table positioning
Drill Press
- Most general purpose drilling jobs
Model
- Make: Axminster
- Model: ED16SB
- Manual: on the Axminster website
Log
- <lovelace_> The chuck for the new stand drill falls out easily
- <lovelace_> I can't see how it tightens up
- <artag> it should be a taper. Assuming it's clean (not got anticorrosion varnish on it) then it should want a good fast whack up into the quill. Not with a hammer - just push it fast, by hand. Use the momentmum of the chuck to get it in hard.
- <artag> if there's a screw thread in the end of the taper thrn it can use a drawbar like the 3-in-1 but that's fairly unlikely
- <creature> Your mum enjoys a good fast whack up into the quill.
- <lovelace_> K, seems firmly in now
- <Randomskk> that's what she said