Difference between revisions of "Equipment/Ultimakers"
m |
m |
||
| Line 15: | Line 15: | ||
|origin=Loan <!-- If via pledge, please link to the completed pledge page on the wiki --> | |origin=Loan <!-- If via pledge, please link to the completed pledge page on the wiki --> | ||
|location=Robotics Area, basement <!-- Floor, room/zone and location within that area --> | |location=Robotics Area, basement <!-- Floor, room/zone and location within that area --> | ||
| − | |maintainers=Rich, Tolland, Chris <!-- If an individual is nominated as managing the upkeep of this item, please list them here. --> | + | |maintainers=Rich, Tolland, Chris?, Ian? <!-- If an individual is nominated as managing the upkeep of this item, please list them here. --> |
|itemId=<!-- Item ID code if available --> | |itemId=<!-- Item ID code if available --> | ||
|template_ver=1.0 <!-- Please do not change. Used for tracking out-of-date templates --> | |template_ver=1.0 <!-- Please do not change. Used for tracking out-of-date templates --> | ||
Revision as of 14:27, 23 September 2015
There are 2 ultimakers currently on loan from "robots for good" project. They are available for use by members under the acnode system. Given the high cost and delicate nature of this equipment training is available to members who have already been inducted for the lulzbot, or have demonstrable previous experience with Ultimaker 3d print hardware.
| Ultimakers 1 & 2 | |
|---|---|
 | |
| Sub-category | CNC |
| Status | Good working order |
| Consumables | Printer filament |
| Training requirement | Yes |
| Training link | 3dprinter_training |
| ACnode | yes |
| Owner | Wevolver |
| Origin | Loan |
| Location | Robotics Area, basement |
| Maintainers | Rich, Tolland, Chris?, Ian? |
Description
ACNode is in operation on the Ultimaker-1, the ultimaker-2 is not yet commissioned. In order for your existing training to be approved on ACNode, you must run through a refresher session to ensure you are upto date (ACNode procedures, Octoprint procedures).
If you have been trained previously and need approved on ACNode, contact the maintainers to be added to the acnode.
Specification & documentation
Printing
- Usable Print Area: 200mm x 190mm x 100mm (7.9in x 7.5in x 3.9in)
- Top Print Speed: 200mm/sec (7.9in/sec)
- Print Tolerance: 0.2mm (0.008in) in X and Y axes. Z axis is dependent on layer thickness
- Layer Thickness: 0.15mm (0.0029in) to 0.35mm (0.029in)
- Supported Materials: ABS and PLA plastic filaments
- Usable Filament Sizes: standard 3mm (0.1in)
Consumables
Only filament provided by the maintainers can be used in the Ultimakers. This is to prevent any issues with poor quality filament. If we're running low on filament (or tape), ro recommended alternative providers, let them know (via the mailing list).
Filament options (3.0mm)
- ABS (lego brick plastic - prints at 190-230 DegC, requires heated bed at 100-110 DegC)
- PLA (biodegradable , based on food starch - prints at 185-190 DegC, optional heated bed, not hotter than 60 DegC)
- There are other 'specialist' filament, like wood effect, stone effect, nylon (can be coloured by clothes dye), etc