Project:Edge-lit table signs
|[[|Edge-lit table signs]]|
|Project Status||revised files & documentation in progress|
We wanted to create illuminated table names for our wedding. Looking for ways to get this done was how I found the hackspace in the first place. I'm writing up the process in case any else wants a quick primer into how to do this.
At one point we were looking at doing a two colour edge lit signs, but couldn't get a second LED strip in exact shade of the wedding colours.
We also lit the seating chart like this, on three 300x600mm perspex sheets. Not nearly as impressive. Always run simulate before kicking off with LaserCut, it's got a couple of bugs.