Difference between revisions of "Silvertail A0 Laser Cutter/Logbook"
Jump to navigation
Jump to search
Line 1: | Line 1: | ||
__NOTOC__ | __NOTOC__ | ||
==Logbook== | ==Logbook== | ||
+ | ===28/09/2016 note by [[User:Solexious|Solexious]]=== | ||
+ | Reports of under powered, checked an was alittle, but not much. Checked alignment with no issues, alight bed miss alignment front to back. Cleaned optics, did test cut with no issues. Put back in order. | ||
+ | |||
+ | Bed needs clean asap, need to look at extraction tubes for slight repairs. | ||
+ | |||
===20/11/2015 note by [[User:Solexious|Solexious]]=== | ===20/11/2015 note by [[User:Solexious|Solexious]]=== | ||
Lens and mirror replaced, helped but tube output needed cleaning too. Done by Russ | Lens and mirror replaced, helped but tube output needed cleaning too. Done by Russ |
Revision as of 18:10, 28 September 2016
Logbook
28/09/2016 note by Solexious
Reports of under powered, checked an was alittle, but not much. Checked alignment with no issues, alight bed miss alignment front to back. Cleaned optics, did test cut with no issues. Put back in order.
Bed needs clean asap, need to look at extraction tubes for slight repairs.
20/11/2015 note by Solexious
Lens and mirror replaced, helped but tube output needed cleaning too. Done by Russ
06/12/2015 note by Solexious
Smaller fan not outputting enough.
Kink in tube and blocked vent to blame. Cleared out. Best to stress to people not to let paper and card get sucked into the vents!