Search results

Jump to: navigation, search
Results 1 - 19 of 19
Advanced search

Search in namespaces:

  
  
  
  
  
  
  
  
  
  
  
  
  • * Volts 230
    450 bytes (58 words) - 10:19, 12 October 2019
  • ...t in amplifier. The loudspeaker terminals on the back can produce up to 40 volts peak to peak and a lot more current than a typical 600ohm signal generator The two fuses on the right hand of the rear panel supply +45volts and -45volts to the amplifier module. The +ve fuse was ok and is a 2amp T fuse. A 250mA
    5 KB (806 words) - 18:22, 8 December 2019
  • ...use the vernier/range buttons to set the upper voltage you want (e.g. 1.2 volt) * Press the 'LOL' button and set the lower voltage (e.g. 0volt)
    4 KB (650 words) - 16:56, 29 May 2013
  • * A 230 volt 110mm angle grinder and a selection of cutting wheels, and suitable gloves
    1 KB (180 words) - 11:27, 11 August 2015
  • ...debug port at 2.5 volts, so you need to construct a circuit to convert the voltages from whatever your using. ''make this circuit (for a bus pirate (bit ba
    2 KB (203 words) - 00:15, 29 May 2013
  • * MEASURE:VOLT:DC ...B address 10 - ask it to identify itself - and then proceed to measure the voltage (this will by default assume autoranging and adjust the settings as need
    3 KB (391 words) - 18:29, 29 May 2013
  • ADC Voltage measurement probe (max 6volts) Vpu Voltage input for on-board pull-up resistors (0-5volts).
    6 KB (952 words) - 00:14, 29 May 2013
  • ...d dimmed operations are stepped. There isn't a linear relationship between voltage and brightness. ! Volts
    1 KB (215 words) - 02:11, 2 March 2019
  • ...00-fog-machine-224416|Prosound 400 N88GB] , Power: 400w , Fuse: T3A/250V , Volts: 230V/50HZ
    3 KB (491 words) - 23:23, 26 September 2013
  • ..., we can deploy these fairly effectively as long as we have an adequate 12 volt power supply to drive them. ...tep Down DC Power Supply Converter] would be useful with all of the 16-19 volt laptop power supplies in bins at the hackspace that have been orphaned due
    8 KB (1,317 words) - 23:45, 16 May 2015
  • ...the other; and then some RS-232 tranceiver (SP213EH) to lift TTL to RS232 voltages. ...similar variant which brings the 5v of the USB logic to the required RS232 voltages. We're now after the 5 FTDI wires:
    3 KB (565 words) - 17:45, 2 October 2011
  • Below are a few examples of topics about power control and design in low voltage circuits, I'm sure some of them overlap. Feel free to add more talks and |The mathematics of electronics, Watts, Ohms, Farads, Coulombs, Amperes, Volts || || |Paul Maidment, [[User:bradwood| Bradley Wood]], [[User:funkyhat| Ma
    3 KB (470 words) - 21:28, 15 January 2014
  • ''2 x Arduino's going pop due to high voltage on PSU's. I have already stopped using these in the kits and requested a ...few random ones from their own stock and confirmed they are all giving 15 volts. I have been promised a refund and I shall use it to purchase regulated 9v
    5 KB (855 words) - 18:08, 8 May 2013
  • * 12 volts, 1 amp output, 1.5 amp maximum (including battery charging)
    4 KB (577 words) - 17:47, 21 July 2012
  • ...wer supply was current limited to 0.8 amps, so voltage dropped to about 80 volts as the electrophoresis progressed)
    22 KB (3,613 words) - 00:17, 25 April 2014
  • ...G rail which can be fed from USB or PWR in, solder bridge selection (diode volts drop too much for wired OR). Solder bridge for VUNREG to VCC or regulator
    6 KB (967 words) - 10:26, 30 November 2011
  • AC Volts in an RC Circuit {{#ev:youtube|boAJIrGaEbU}}
    8 KB (1,199 words) - 16:33, 20 August 2016
  • ...wear) tungsten tip where a plasma 'flame' is created (started with a high-voltage / high frequency starter) and used to heat the filler wire and joint. Th ...socket connection is used, with a pushbutton on/off control station and no-volt release.<br/>
    8 KB (1,198 words) - 22:20, 6 February 2020
  • ...a bolt designed to induce neuromuscular incapacitation; and therefore 1200 volts instead of a creep. ...Cambridge and none at all in the hackspace. It is very sensitive to supply voltage smoothness.
    11 KB (1,923 words) - 17:33, 28 May 2013