1,143
edits
(Created page with '0xfe00 = software reset') |
|||
(3 intermediate revisions by 3 users not shown) | |||
Line 1: | Line 1: | ||
0xfe00 = software reset | 0xfe00 = software reset | ||
SPI = rising edge, 16 bit | |||
Interrupts (nIRQ low) for: | |||
when in appropriate mode: | |||
RGIT (TX register ready for data) | |||
RGUR (TX register underrun) | |||
FFIT (RX FIFO has data) | |||
FFOV (RX FIFO overflow) | |||
POR (power-on reset) | |||
WKUP (wake-up timer) | |||
EXT (nINT) | |||
LBD (low battery) | |||
SDO runs all the time. | |||
[EvanDavey] | |||
Have you looked at http://www.seeedstudio.com/depot/datasheet/RFBee%20User%20Manual%20v1.1.pdf? | |||
The design leaves lots of digital pins free on the AT Mega (which uses the Arduino bootloader) which I reckon would suit most applications and the CC1101 is cheap. Been thinking of trying to reproduce this on a breadboard using their design and firmware + regulator hardware. |
edits