Search results

...n you have enough skill to use it without damaging yourself, others or the tool. ...owever, so it is still recommended you look into the "proper" way to use a tool. You may learn some nifty expert tricks in the process!

|subcat=Debug tools<!-- Sub-category if one exists. Please check main listing to see other cat ...u mention [https://en.wikipedia.org/wiki/Rubber_duck_debugging rubber duck debugging].

...goryID=123 VNC2 Debug Module (VNC2)] - the little board pictured - used to debug the VNCLO-START1. ...SB Host/Device controller, combining the Vinculo motherboard with the VNC2 Debug/Programming module. The Vinculum-II supports dual USB Host/Device interface

==Tools.== ...ted to it together with their configuration data. This is very useful for debugging USB enumeration errors. USBView runs under Windows 98, ME, 2000 and XP

...urnt code on the YAAC running Windows Vista SP3 on the host, using the AVR toolchain - as per Benito 7 and Nanduino recipes. I don't know about running the # Select the Teensyduino device from menu Tools > Board > Teensy 1 (USB Serial)

# | +------------------ DWEN (debug wire enable) # | +------------------ DWEN (1 = debug wire disable)

ATTiny rather than other MCUs for good free tool (GCC etc) support. * a few excess pins to allow for in-crcuit reprogramming and debugging (which i think means dont use MOSI,MISO,SCLK or RESET in the applicatio

...ay wish to use the open source GCC C compiler directly with AVRdude or the toolset provided by Atmel in AVR Studio. In the Arduino application menu Tools/Board select "Arduino Duemilanove or Nano w/ ATmega328"

...o mechanical making facilities but not necessarily electronics, especially debug skills and test equipment. ==Fundraising for Tools Purchases==

* Detailed technical design work using available CAD tools ...ng with new ideas for ways to extend, modify, hack and create new kits and tools to inspire for millions of families and young people to join the maker gen

The tw_cli command line tool can reconfigure the megaraid controllers without having to go into the bios |dump of the environment, useful for debugging

<tomwyatt> debugging by brownian motion < ajp5> the perlcode was debugged, but of the libary we dispaired

** have some larger pipe in tools at home - need cap and taps to match * JTAG debugging

* [http://www.rapidonline.com/tools-equipment/photoetch-pcb-29445 Photoetch PCB (Rapid)] ...could use the [http://www.ebay.co.uk/itm/Dremel-220-01-Workstation-Rotary-Tool-Multi-Purpose-Drill-Press-/271486781801?_trksid=p2054897.l5658 Dremel stand