75
edits
Gantry CNC: Difference between revisions
From London Hackspace Wiki
no edit summary
No edit summary |
No edit summary |
||
| Line 11: | Line 11: | ||
|trainlink=<!-- If training is required, provide a link to training signup or contact page. Otherwise leave blank. --> | |trainlink=<!-- If training is required, provide a link to training signup or contact page. Otherwise leave blank. --> | ||
|acnode=Yes <!-- Is the equipment ACnode locked? --> | |acnode=Yes <!-- Is the equipment ACnode locked? --> | ||
|owner=LHS <!-- Provide a link to owners members page if other than LHS --> | |owner=LHS (spindle and VFD currently on loan) <!-- Provide a link to owners members page if other than LHS --> | ||
|origin=LHS Built<!-- If via pledge, please link to the completed pledge page on the wiki --> | |origin=LHS Built<!-- If via pledge, please link to the completed pledge page on the wiki --> | ||
|location=Basement, Robotics area<!-- Floor, room/zone and location within that area --> | |location=Basement, Robotics area<!-- Floor, room/zone and location within that area --> | ||
| Line 17: | Line 17: | ||
|template_ver=1.1 <!-- Please do not change. Used for tracking out-of-date templates --> | |template_ver=1.1 <!-- Please do not change. Used for tracking out-of-date templates --> | ||
}} | }} | ||
== Summary == | |||
We made this CNC from the donated linear slides and stages, and other things lying around the space, and some bits and pieces that members had. All suggestions for improvements / modification are welcome! | |||
== Specs == | == Specs == | ||
* Spindle 1000 to 20000rpm | * Spindle 1000 to 20000rpm | ||
* Rapid traverse rate at 100% 2000mm/min | * Rapid traverse rate at 100% 2000mm/min | ||
* Axis travel | * Axis travel | ||
**X(longitudinal) 800mm | **X(longitudinal) 800mm | ||
** Y(cross) 960mm | ** Y(cross) 960mm | ||
** Z(vertical) 80mm (Phase 1), 280mm (Phase 2) | ** Z(vertical) 80mm (Phase 1), 280mm (Phase 2) | ||
== Technical == | |||
The system currently runs GRBL 0.9 and is very similar to use to the [https://wiki.london.hackspace.org.uk/view/Equipment/Shapeoko2 Shapeoko2]. | |||
To start the spindle, press the green button on the VFD. Use the up and down keys to vary the speed. | |||
