Equipment/HPC LS3060 Laser Cutter/LogBook: Difference between revisions
From London Hackspace Wiki
Equipment/HPC LS3060 Laser Cutter/LogBook (view source)
Revision as of 14:26, 19 September 2010
, 19 September 2010→Logbook
| Line 6: | Line 6: | ||
* A Cthulu keyring was made on 2mm acrylic towards the end of the day. We did notice a few problems with this, namely at one point a hole came out non-circular, but also the etched layer didn't align correctly with the cut layer, out by about 2mm. No explanation for these at this point. | * A Cthulu keyring was made on 2mm acrylic towards the end of the day. We did notice a few problems with this, namely at one point a hole came out non-circular, but also the etched layer didn't align correctly with the cut layer, out by about 2mm. No explanation for these at this point. | ||
* I tried making a PCB, but should have used single sided copper. | * I tried making a PCB, but should have used single sided copper. | ||
===16/09/2010 Operator [[User:Solexious|Solexious]]=== | |||
* Cut out the [http://www.flickr.com/photos/solexious/4999127940/ coin slot] peices for the 4 in a row donations box | |||
* Small bumps formed on the side of the acrylic closest to the bed where the honeycomb was touching, will try to correct with +1 to speed setting. | |||
* Extraction is improved and unwanted smell is reduced with sheets of acrylic that are full bed size. | |||
* No other problems detected. | |||
===15/09/2010 Operator [[User:Russ|Russ]]=== | ===15/09/2010 Operator [[User:Russ|Russ]]=== | ||
