93
edits
Laser Cutter/Instructions: Difference between revisions
From London Hackspace Wiki
Add password for laser cutter machine
Mich181189 (talk | contribs) (→Software packages: Just spent a couple of hours working out how to get from FreeCAD to Lasercut53 - making notes to save someone else the pain) |
(Add password for laser cutter machine) |
||
| Line 3: | Line 3: | ||
Refresher instructions found at [[Equipment/LaserCutter/Refresher]] | Refresher instructions found at [[Equipment/LaserCutter/Refresher]] | ||
==Powering on== | ==Powering on== | ||
# Place your card on the reader, insert key and turn | # Place your card on the reader, insert key and turn. | ||
#* If you turn the key on and nothing happens, check that the Emergency Stop (the big red button) is not locked down. If it is, turn it until is springs up and the machine should power up. | #* If you turn the key on and nothing happens, check that the Emergency Stop (the big red button) is not locked down. If it is, turn it until is springs up and the laser cutter machine should power up. | ||
# The PC is turned on using the 'e' button on the front of the PC (black PC with DNH "CCTV machine" label). | |||
#* The password for the PC (the Laser Cutter User) is: "hackspace" | |||
# '''Always''' perform the following pre-checks: | # '''Always''' perform the following pre-checks: | ||
## Check that there is a '''CO<sub>2</sub>''' fire extinguisher '''immediately to hand'''. | ## Check that there is a '''CO<sub>2</sub>''' fire extinguisher '''immediately to hand'''. | ||
