Difference between revisions of "Door control system/Logbook"
Jump to navigation
Jump to search
(Created page with 'To try: * Physical reset button on arduino (see if it flashes digital pins) * 120 ohm resistor between 5V and RSET on arduino * Replace diode on solenoid') |
|||
Line 1: | Line 1: | ||
+ | Problems: | ||
+ | |||
+ | * Arduino resets on serial open() from bifferboard (including explicit disabling of DTS) | ||
+ | * Arduino flashes digital outputs high on reset | ||
+ | * Digital output flashing high triggers door open | ||
+ | |||
To try: | To try: | ||
Line 4: | Line 10: | ||
* 120 ohm resistor between 5V and RSET on arduino | * 120 ohm resistor between 5V and RSET on arduino | ||
* Replace diode on solenoid | * Replace diode on solenoid | ||
+ | * Use a capacitor to smooth over the reset pulse, requiring > 1 second to trigger relay | ||
+ | * Rebuild transistor/relay board | ||
+ | * Use a solid state relay (no transistor required) |
Revision as of 10:01, 27 September 2010
Problems:
- Arduino resets on serial open() from bifferboard (including explicit disabling of DTS)
- Arduino flashes digital outputs high on reset
- Digital output flashing high triggers door open
To try:
- Physical reset button on arduino (see if it flashes digital pins)
- 120 ohm resistor between 5V and RSET on arduino
- Replace diode on solenoid
- Use a capacitor to smooth over the reset pulse, requiring > 1 second to trigger relay
- Rebuild transistor/relay board
- Use a solid state relay (no transistor required)