Door control system/Logbook: Difference between revisions
From London Hackspace Wiki
No edit summary |
No edit summary |
||
| Line 1: | Line 1: | ||
Problem: | === 2010-09-27 === | ||
Problem (identified by solexious at the weekend): | |||
* Arduino resets on serial open() from bifferboard | * Arduino resets on serial open() from bifferboard | ||
* Arduino flashes digital outputs high on reset | * Arduino flashes digital outputs high on reset | ||
* Digital output flashing high triggers door open | * Digital output flashing high triggers door open | ||
Tried: | |||
* Disabling DTS (didn't work) | |||
* | |||
To try: | To try: | ||
| Line 20: | Line 27: | ||
To try: | To try: | ||
* Replace with header/plugs | * Replace with header/plugs | ||
Problem: | |||
* Flashing arduino has stopped working (stk500v1: no response) | |||
To try: | |||
* Another arduinio | |||
Revision as of 10:16, 27 September 2010
2010-09-27
Problem (identified by solexious at the weekend):
- Arduino resets on serial open() from bifferboard
- Arduino flashes digital outputs high on reset
- Digital output flashing high triggers door open
Tried:
- Disabling DTS (didn't work)
To try:
- Physical reset button on arduino (see if it flashes digital pins)
- 120 ohm resistor between 5V and RSET on arduino
- Replace diode on solenoid
- Use a capacitor to smooth over the reset pulse, requiring > 1 second to trigger relay
- Rebuild transistor/relay board
- Use a solid state relay (no transistor required)
Problem:
- Chocolate block "plug" is loose, sometimes causing loss of power at slightest touch
To try:
- Replace with header/plugs
Problem:
- Flashing arduino has stopped working (stk500v1: no response)
To try:
- Another arduinio
