Project:PCB Making

From London Hackspace Wiki

Revision as of 17:01, 27 March 2010 by 86.26.167.84 (talk) (How to make a Printed Circuit Board (PCB).)
(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)

Project maintained by Daniel Sikar ~/ dsikaratgmaildotcom.

Project Brief

Summary

How to make a Printed Circuit Board (PCB) using photoresist laminates.

Overview

This howto is intended as a module, aimed at providing building blocks to emulate and extend the Nanduino

project.

Motivation

PCB making autonomy, although not an absolute necessity in this day and age, is helpful.

Once an electronic prototype is working on a breadboard, the next logical step is to firm up all components on a PCB, where they are less likely to come apart.

Bringing electronic designs to life engenders spacial awareness and can also be fun.

The bigger picture

There are several steps in producing electronic gadgets. PCB making comes in after the artwork is ready to be transferred and before the components are ready to be soldered onto the board.

Method

The method described consists of exposing, developing (etching), tinning and drilling a copper-clad board.

Bill of Materials (BOM)

  1. Photoresist Copper-clad board Maplin product page (code FA61R).
  2. Sodium Silicate Maplin product page (code AP01B).
  3. Ferric Chloride Maplin product page (code XX12N).
  4. Methylated spirits Wickes product page (code 600343).
  5. Flux pen Maplin product page (code N63AA).

Additionally:

  • Scale
  • Tubs
  • Mixing and storing vessels
  • UV exposure box
  • Hammer & punch
  • Drill & drill bits

Steps in a nutshell

  1. The artwork (printed onto a transparency) is placed over the photoresist copper-clad board and exposed to UV light.
  2. The photo sensitive coating weakens as a result of exposure, and is rinsed off with a 10% Sodium Silicate solution.
  3. Copper-clad board is immersed in a 30% Ferric Chloride solution until etched.
  4. Remaining photo sensitive coating is removed with Methylated spirits. This can also be achieved by scrubbing the etched board with wire wool.
  5. Board is drilled to allow mounting of Through Hole (TH) components.

An additional step is to coat the finished board with an insulating layer which prevents short circuits in case of electricity conducting objects coming in contact with the copper trails. This can be distinguished by a varnish (often green) finish, seen in commercial PCBs.