Project:Ubuntu Goblin

Ubuntu Goblin
QR code

Phase 1 - Mod the Shell

First you have to remove the shell from the laptop so you don't get any paint on the screen or on the internal components, being patient and removing the case completely will make the job a whole lot easier and the end result much cleaner. It's wise to test the spray paint on the underneath of your shell first, just a small section to make sure it doesn't warp or burn the plastic! Then while the shell dries print off and cut out your stencils, or simply buy them.
I printed and cut my own, it took about an hour or so.

A simple laptop mod using homemade templates and a few cans of spray paint!
More photos on the HackSpace flickr page.. [1]

Phase 2 - No Integrated Webcam? no problem..

If you're thinking of trying this mod on your own laptop, then check your laptop user manual and the motherboard as it might already support an integrated webcam. My laptop didn't come with a built-in webcam and the motherboard doesn't support one, but that didn't stop me trying to fit it. You can buy integrated webcams complete with usb connector cables for about £8-15 on Ebay, mine cost £8 including postage. The first problem I had when it arrived was to figure out which wires corresponded with the connections on the rear of my usb port. At this point all I can advise is that you do your research on Google, USB connections are pretty generic, but the wire coding can vary between USB devices.

Integrated a webcam into the screen. Ordered a webcam from Ebay, although the camera was for a different model I did manage to solder it directly onto a usb port. Checkout [2] for the images!