Environmental Chamber: Difference between revisions

From London Hackspace Wiki

Environmental Chamber (view source)

Revision as of 16:46, 19 December 2012

232 bytes removed ,  19 December 2012
→‎Controls
Line 41: Line 41:
The user interface is still a mystery to me but I pressed buttons until the top red numbers showed current temperature, the lower red numbers showed "100.0" (desired temperature) and the XK1 and "hand" red LEDS were illuminated. I left the green switch with a snowflake symbol off.
The user interface is still a mystery to me but I pressed buttons until the top red numbers showed current temperature, the lower red numbers showed "100.0" (desired temperature) and the XK1 and "hand" red LEDS were illuminated. I left the green switch with a snowflake symbol off.
The temperature shot up to 50degC quite rapidly then took a couple of minutes to get to 100degC. The XK1 led flashed when it was at 99.9degC. --AJP
The temperature shot up to 50degC quite rapidly then took a couple of minutes to get to 100degC. The XK1 led flashed when it was at 99.9degC. --AJP
<B> Simple temperature-setting instruction:
Press and hold (3s ish) 'hand' button until the display shows 'SETP'.
Set required temperature using up and down arrow buttons.
Press and hold (1s) 'enter' button, twice.  --PaddyD </B>


Below is a manual for the controller in the oven. Please note that it is generic: it does not refer to this particular implementation... :)  
Below is a manual for the controller in the oven. Please note that it is generic: it does not refer to this particular implementation... :)  
Retrieved from ‘https://wiki.london.hackspace.org.uk/view/Special:MobileDiff/27075’