Laser Cutter/Instructions: Difference between revisions
From London Hackspace Wiki
705 bytes removed
, 12 March 2022
|
|
| Line 59: |
Line 59: |
|
| |
|
| ==Uploading your data file== | | ==Uploading your data file== |
| * Upload your design and settings to the laser cutter hardware as follows:
| |
| ** Select the 'Download' button
| |
| [[File:Laser-Cutter-Screen-Download.png|center|'Download' button]]
| |
| ** Troubleshooting: If clicking 'Download' results in a "The communication is broken for timeout. Please close and open the output window to retry." then the laser cutter is probably not turned on. Place your card on the reader and turn the key.
| |
| ** Remove any existing files by selecting them and clicking 'Del all'
| |
| ** Download (upload) your file by clicking 'Download current'
| |
| If you get a "Soft Stop" error, this is often caused by part of the design being out of bounds of the cutting area. Correct the design and try again.
| |
|
| |
|
| ==Positioning your material== | | ==Positioning your material== |
