Project:PizzaPrinter: Difference between revisions
From London Hackspace Wiki
→Liquid dispensers
(→Liquid dispensers: Thingiverse link for pump) |
|||
| Line 36: | Line 36: | ||
** Agreed on the concept - makes sense to keep things as clean as possible - should be fairly easy to make with a few rollers attached to a printed/metal frame on the end of a motor. --[[User:JamesHarrison|James Harrison]] 18:28, 2 August 2010 (UTC) | ** Agreed on the concept - makes sense to keep things as clean as possible - should be fairly easy to make with a few rollers attached to a printed/metal frame on the end of a motor. --[[User:JamesHarrison|James Harrison]] 18:28, 2 August 2010 (UTC) | ||
** You can apparently make one with a laser cutter http://www.thingiverse.com/thing:167 --[[User:Eb4890|Eb4890]] 17:03, 26 October 2010 (UTC) | ** You can apparently make one with a laser cutter http://www.thingiverse.com/thing:167 --[[User:Eb4890|Eb4890]] 17:03, 26 October 2010 (UTC) | ||
*** This one looks 300x easier to make though http://www.thingiverse.com/thing:5265 --[[user:ciaran.moooney|Ciarán]] | |||
**Could also use a suction placement - mostly good for pick & place salami etc. but might also suck liquid up a short tube then blow it down : able to use the same mechanism for both solids and liquid dispensing. | **Could also use a suction placement - mostly good for pick & place salami etc. but might also suck liquid up a short tube then blow it down : able to use the same mechanism for both solids and liquid dispensing. | ||
