Difference between revisions of "Equipment/Britannia Lathe"
Jump to navigation
Jump to search
(Created page with " == Britannia lathe renovation == 27/5/2013 Removed tool board from back board. it's stored under/behind the lathe cabinet. Cut bit of wood for the motor to sit on. it's si...") |
|||
Line 1: | Line 1: | ||
− | + | {{EquipmentInfobox | |
+ | | category = Equipment <!-- Main category. Please leave alone to keep item in this category --> | ||
+ | | subcat = Metalworking <!-- Sub-category if one exists. Please check main listing to see other | ||
+ | }} | ||
== Britannia lathe renovation == | == Britannia lathe renovation == | ||
Line 5: | Line 8: | ||
There is a potential 12VDC in my box, will need to make a speed controller for it. Alternatively just use a normal mains motor with a step pully as the lathe was designed for. 3 phase motors with inverter speed controllers start to look expensive. | There is a potential 12VDC in my box, will need to make a speed controller for it. Alternatively just use a normal mains motor with a step pully as the lathe was designed for. 3 phase motors with inverter speed controllers start to look expensive. | ||
+ | [[Category:Tools for use on metal]] |
Revision as of 16:46, 27 May 2013
{{EquipmentInfobox | category = Equipment | subcat = Metalworking