Difference between revisions of "Equipment/Britannia Lathe"
Jump to navigation
Jump to search
| Line 1: | Line 1: | ||
| − | + | ||
| − | |||
| − | |||
| − | |||
== Britannia lathe renovation == | == Britannia lathe renovation == | ||
Revision as of 16:47, 27 May 2013
Britannia lathe renovation
27/5/2013 Removed tool board from back board. it's stored under/behind the lathe cabinet. Cut bit of wood for the motor to sit on. it's sitting in place for now with a sign not to remove. Will fasten it in place permanently when final motor decision is made.
There is a potential 12VDC in my box, will need to make a speed controller for it. Alternatively just use a normal mains motor with a step pully as the lathe was designed for. 3 phase motors with inverter speed controllers start to look expensive.