View source for Risk Assessment/ Metal Milling Machines

__NOTOC__

=Risk Assessment - Metal Milling Machines=

This risk assessment is intended to provide guidance on the risk associated with the above equipment and activities in normal use. Please also check general risk assessments for the space as a whole. Any discrepancies, errors or concerns should be raised with the document maintainers or trustees - do not edit this assessment directly. For responsible persons and last update, see 'version log' of the assessment page.

===Activity===

Cutting metal or suitable plastics on the metal mill

===Signage===

<gallery mode=nolines widths=200>
Wear Eye Protection.jpg
Wear Ear Protection.jpg
Read Instruction Manual.jpg
Induction Required.jpg
Use Appropriate Guards.jpg
Use Dust Extraction.jpg
No Loose Clothing or Gloves.jpg
</gallery>

===Understanding Risk Rating===

LOW	-    Ensure current control measures are in place and continue with activity

MED	-    Control measures may be adequate, co-supervision is recommended

HIGH	-    Do not undertake activity without further consultation with area specialists

===Risk Assessment===

{| class="wikitable"
|-
! Identify Hazards !! Who May be Harmed and How !! Severity !! Control Measures !! Likelihood !! Risk Rating
|-
| Incompetent user || User, Bystander || HIGH       || Users must not use tools that they are not competent to use. Members must challenge use that they believe is dangerous. All members wishing to use the mill must be trained. Users must read the risk assessment before using a tool. || LOW      || MED   
|-
| Contact with cutter || User || HIGH      || Do not touch moving parts of machine once in use. Do not put hands behind the guard –If swarf removal is needed use a brush. Mill should be switched off immediately after use. Do Not Wear Gloves or loose clothing when operating the machine. Tie long hair back when operating the machine || LOW      ||  MED 
|-
| Ejection of workpiece (Kickback) || User of the tool, users of the room, the space. || HIGH      || Use a machine vice where possible. Make sure the part is secured in the vice or to the table before starting acut. Cuts should not exceed recommended cutting depth or feed. Parts attached directly to the bed must be securely clamped. The vice or other workholding jigs must be attached securely to the bed. Other users of the room should not be close to the machine. The machine should be used with it’s guard attached, when possible. Support for parts, in the form of parallels, centres, jacks, etc, should be used where appropriate.  || LOW   || MED   
|-
| Cutter || User of the tool, users of the room, the space. || LOW || Do not exceed the recommended feed and speed settings of the mill. Do not exceed recommended cutting depths. Make sure that your material is free from foreign objects. Do not make a cut that exceeds your material depth. Ensure cutter is sharp before use. Side-cutting tools are not to be held in a Jacobs chuck. The machine should be used with it’s guard attached, when possible || MED     || LOW
|-
| Noise || User of the tool, users of the room. || LOW || Ear protection is advised, particularly on harder materials || LOW  || LOW
|-
| Flying || User of the tool, users of the room. || MED   || Eye protection must be worn whilstusing the mill. Eye protection must be worn by all users of the workshop. Do not exceed the recommended feed and speed settings on the mill. Do not exceed recommended cutting depths. Make sure that your material is free from foreign objects. Do not make a cut that exceeds your material depth. Ensure cutters are sharp before use. Ensure the drawbar is tight before starting the machine. The machine should be used with it’s guard attached, when possible   || MED  || MED
|-
|}

[[Category:Risk Assessment]]