Silvertail A0 Laser Cutter/Logbook
From London Hackspace Wiki
Logbook
28/09/2016 note by Solexious
Reports of under powered, checked an was alittle, but not much. Checked alignment with no issues, alight bed miss alignment front to back. Cleaned optics, did test cut with no issues. Put back in order.
Bed needs clean asap, need to look at extraction tubes for slight repairs.
Extra note,someone has changed the machine settings to run at 100% power, rather than the correct rated amount.
20/11/2015 note by Solexious
Lens and mirror replaced, helped but tube output needed cleaning too. Done by Russ
06/12/2015 note by Solexious
Smaller fan not outputting enough.
Kink in tube and blocked vent to blame. Cleared out. Best to stress to people not to let paper and card get sucked into the vents!
