Project:25-hpamakers-reprap: Difference between revisions

Project:25-hpamakers-reprap (view source)

529 bytes removed , 11 May 2011

434

edits

@@ Line 123: / Line 123: @@
 ==How?==
-===Development Milestones===
+===Current Development Milestones===
-====Ordering====
+====1-Firmware====
-Obtain all the parts to make our Mendel
+ (Sam)RepRap Motherboard v1.2 firmware installation.
-  Check Parts List (27/6/10).
+ Notes:
-  Order Leftover Parts (complete 28/6/10).
-====Construction====
-Begin Construction: [http://reprap.org/wiki/Mendel_Build_Manual Build Manual]
-Downloading and Installing RepRap on your computer
- Latest build from sourceforge.
-Circuit board construction
+====2-Testing====
-.1 Soldering Opto Endstops x 3 (completed 1/7/10).
+  (Sam) Check Wiring + Firmware:  Desktop-based test of all stepper motors and electronics.
-.2 Soldering USB to Serial.
+  Notes:
-.3 Makerbot Stock PCB for usage as Mendel [http://reprap.org/wiki/PCB_adaptions_for_Mendel Modification].
-.4 Modify ATX power supply with XLR connector (completed 1/7/10).
-Microcontroller firmware installation
+ (Kal) Check Mechanical Construction against instructions + Begin Calibrating
+ Notes:
+====3-Commissioning====
-Mechanical construction
-Electronic wiring
-====Testing====
- Check Electronic Wiring
- Check Firmware
- Check Mechanical Construction
-Stepper Motor Drivers + Mainboard
-Finish Testing
-====Commissioning====
   Begin printing
   Make first model