434
edits
Project:25-hpamakers-reprap: Difference between revisions
From London Hackspace Wiki
m
→Current Development Milestones
Samthetechie (talk | contribs) |
Samthetechie (talk | contribs) |
||
| Line 20: | Line 20: | ||
4 x PLA Bushings printed at 19:07 on Wed 11th May 2011 by Kal | 4 x PLA Bushings printed at 19:07 on Wed 11th May 2011 by Kal | ||
====2-Firmware==== | ====2-Electronics==== | ||
(Sam) Makerbot to Reprap PCB Adaptations. | |||
====3-Firmware==== | |||
(Sam)RepRap Motherboard v1.2 firmware installation. | (Sam)RepRap Motherboard v1.2 firmware installation. | ||
Notes: | Notes: | ||
==== | ====4-Testing==== | ||
(Sam) Check Wiring + Firmware: Desktop-based test of all stepper motors and electronics. | (Sam) Check Wiring + Firmware: Desktop-based test of all stepper motors and electronics. | ||
Notes: I am going to be flashing the firmware using an FTDI cable and then I will check our USB to serial cable. | Notes: I am going to be flashing the firmware using an FTDI cable and then I will check our USB to serial cable. | ||
| Line 34: | Line 37: | ||
We might need to cut some more steel stock if any of the lengths are too short. | We might need to cut some more steel stock if any of the lengths are too short. | ||
==== | ====5-Commissioning==== | ||
Begin printing | Begin printing | ||
Make first model | Make first model | ||
