556
edits
Laser Cutter/Instructions: Difference between revisions
From London Hackspace Wiki
→Knowing the correct Z-Axis position
| Line 65: | Line 65: | ||
===Knowing the correct Z-Axis position=== | ===Knowing the correct Z-Axis position=== | ||
The bed height must be adjusted to the thickness of your material so as to ensure the focus point of the beam is in the optimal position for your task. The focus point of the beam corresponds with the | The bed height must be adjusted to the thickness of your material so as to ensure the focus point of the beam is in the optimal position for your task. The focus point of the beam corresponds with the top edge of the vertical ruler that is attached to the back of the cutting area, this corresponds to the bottom edge of the horizontal ruler that runs along the length of the bed. So: | ||
* For cutting materials <=8mm, the bed height should be | * For cutting materials <=8mm, the bed height should be set to the focus point, making the bottom of your material the focus point of the laser (i.e. the top of the cutting bed should line up with the top of the vertical ruler). | ||
* For cutting materials >8mm, the bed height needs to be adjusted such that the focus point is in the mid point of the material. | * For cutting materials >8mm, the bed height needs to be adjusted such that the focus point is in the mid point of the material. | ||
* For engraving, the focus point should be the top of your material. | * For engraving, the focus point should be the top of your material. | ||
