306
edits
Laser Cutter/Instructions: Difference between revisions
From London Hackspace Wiki
→Knowing the correct Z-Axis position: removed incorrect picture since the laser focus height has changed according to solexious
(→Knowing the correct Z-Axis position: added pic) |
(→Knowing the correct Z-Axis position: removed incorrect picture since the laser focus height has changed according to solexious) |
||
| Line 64: | Line 64: | ||
===Knowing the correct Z-Axis position=== | ===Knowing the correct Z-Axis position=== | ||
The bed height must be adjusted to the thickness of your material so as to ensure the focus point of the beam is in the optimal position for your task. The focus point of the beam corresponds with the top edge of the vertical ruler that is attached to the back of the cutting area. It's worth noting that this is at the same height as the bottom edge of the horizontal ruler that runs along the length of the bed so may be easier to judge the correct height using that albeit a bit less intuitive to remember. So: | The bed height must be adjusted to the thickness of your material so as to ensure the focus point of the beam is in the optimal position for your task. The focus point of the beam corresponds with the top edge of the vertical ruler that is attached to the back of the cutting area. It's worth noting that this is at the same height as the bottom edge of the horizontal ruler that runs along the length of the bed so may be easier to judge the correct height using that albeit a bit less intuitive to remember. So: | ||
* For cutting materials <=8mm, the bed height should be set to the focus point, making the bottom of your material the focus point of the laser (i.e. the top of the cutting bed should line up with the top of the vertical ruler). | * For cutting materials <=8mm, the bed height should be set to the focus point, making the bottom of your material the focus point of the laser (i.e. the top of the cutting bed should line up with the top of the vertical ruler). | ||
