76
edits
Equipment/Stratasys FDM 1650: Difference between revisions
From London Hackspace Wiki
→TODO
(→TODO) |
|||
| Line 7: | Line 7: | ||
==TODO== | ==TODO== | ||
*1. Remove all the unnecessary wiring, including the old heater tubes. | |||
*2. Identify the wiring on the steppers (these are wired differently to normal). | |||
*3. Connect the motors to the 4pi (http://wiki.arcol.hu/blog:4pi) and calibrate the settings. | |||
*4. Redesign the head end for 2 hot-ends and extruders. | |||
*5. Connected hot ends and run heat and thermistor checks. | |||
*6. Filament path checks. | |||
*7. Install Raspberry Pi with Octoprint. | |||
*8. Calibration test print. | |||
*9. Heated bed design (required for ABS), phase 2. | |||
| Line 47: | Line 55: | ||
*Write translator to perform the above conversion | *Write translator to perform the above conversion | ||
==Current Status - 4/11/11== | ==Current Status - 4/11/11== | ||
