146
edits
Laser Cutter/Instructions: Difference between revisions
From London Hackspace Wiki
→Checking cutting boundaries: Added notes on accuracy of the pointer.
(→Preparing your design: Add a line about colours to layers section.) |
(→Checking cutting boundaries: Added notes on accuracy of the pointer.) |
||
| Line 95: | Line 95: | ||
*: [[File:Laser-Cutter-Screen-Run-box.png|center|'Run box' button ]] | *: [[File:Laser-Cutter-Screen-Run-box.png|center|'Run box' button ]] | ||
* Observe the path of the red-dot pointer | * Observe the path of the red-dot pointer | ||
The red-dot pointer beam does not follow the same path as the cutting laser, and only gives a rough idea of position of the laser beam, varying accuracy dependant upon Z height. | |||
Leaving a 10mm border is recommended. Cutting too close to the edge of materials also increases the chance of risk of fires. | |||
For engraving onto and existing object, test positioning by placing a piece of paper on top, and running the design on very high speed, and low power. | |||
==Cutting== | ==Cutting== | ||
