179
edits
PCB etching instructions: Difference between revisions
From London Hackspace Wiki
→Etch
(→Etch) |
|||
| Line 83: | Line 83: | ||
The Cupric Chloride etchant is in [[Equipment/PCB_etch_station#2nd_Tank_-_Etchant|tank B]] | The Cupric Chloride etchant is in [[Equipment/PCB_etch_station#2nd_Tank_-_Etchant|tank B]] | ||
Follow instructions on the notice, but the board is done when all the exposed copper is removed. The balance is removing too much copper and getting breaks in traces vs not enough and some small closely laid traces may have bridges. | Follow instructions on the notice, but the board is done when all the exposed copper is removed. The balance is removing too much copper and getting breaks in traces vs not enough and some small closely laid traces may have bridges. You are looking for clean edges to your traces - not wobbley "chewed" looking edges. | ||
== Stripper == | == Stripper == | ||
