927
edits
Equipment/Vending machine: Difference between revisions
From London Hackspace Wiki
no edit summary
No edit summary |
No edit summary |
||
| Line 34: | Line 34: | ||
==Updates== | ==Updates== | ||
* 15-JUN-2014: Updated (routed) motor control board is at https://github.com/londonhackspace/vend | * 15-JUN-2014: Updated (routed) motor control board is at https://github.com/londonhackspace/vend | ||
* 16-DEC-2014: Switching to use the connected launchpads (like the new ACnode), Paddy nearly making the KiCad footprints | <S>* 16-DEC-2014: Switching to use the connected launchpads (like the new ACnode), Paddy nearly making the KiCad footprints</S> | ||
* 18-JAN-2015: Routing's been done. Presumably just needs etching and assembling now | <S>* 18-JAN-2015: Routing's been done. Presumably just needs etching and assembling now</S> | ||
* 25-NOV-2015: Boards ordered and on their way from China | <S>* 25-NOV-2015: Boards ordered and on their way from China</S> | ||
* 8-MAR-2016: Board is built, rails are good. Checked internal wiring is good. Taken 2 motors as test subjects to do initial comparator setup etc.. Paddy | <S>* 8-MAR-2016: Board is built, rails are good. Checked internal wiring is good. Taken 2 motors as test subjects to do initial comparator setup etc.. - Paddy </S> | ||
* 5-JUL-2016: Board now working, drivers drive motors, comparators correctly detect motor off, run + jam conditions - Paddy | |||
== To do == | == To do == | ||
* Create board to drive motors (24V) | <S>* Create board to drive motors (24V)</S> | ||
** Schematic done. pcb layout proceeding. docs in [https://github.com/artag/vend github], help welcome (artag) | <S>** Schematic done. pcb layout proceeding. docs in [https://github.com/artag/vend github], help welcome (artag)</S> | ||
* Write firmware | |||
* Fit board + psu (psu ordered 6-7-16 Paddy) | |||
* <s>Soldering for connector</s> | * <s>Soldering for connector</s> | ||
| Line 51: | Line 55: | ||
**What is the state of front locks ? We should still have the cams from the old ones | **What is the state of front locks ? We should still have the cams from the old ones | ||
* Set up first minimal operation, using breadboard. All laid out - <s>just need values for the current sensing resistors.</s> just need the new driver board. | <S>* Set up first minimal operation, using breadboard. All laid out - <s>just need values for the current sensing resistors.</s> just need the new driver board.</S> | ||
Later: | Later: | ||
* Make break beam for successful vend detector | * Make break beam for successful vend detector | ||
* Interface with coin/note reader | * Interface with coin/note reader | ||
* Make a new pcb for interfacing with VDU | * Make a new pcb for interfacing with VDU ? | ||
* Make replacement keypad | * Make replacement keypad | ||
* test interface with motors | <S>* test interface with motors</S> | ||
* add in i2c rfid reader | * add in i2c rfid reader | ||
* shorten and remake coin validator cable | * shorten and remake coin validator cable | ||
