13
edits
Equipment/Bus Pirate: Difference between revisions
From London Hackspace Wiki
→How to get a shell anything UART
| Line 88: | Line 88: | ||
=== How to get a shell anything UART === | === How to get a shell anything UART === | ||
Follow this step to get a shell using the bus pirate to you UART devices. | Follow this step to get a shell using the bus pirate to you UART devices. | ||
* | * First find the UART baud rate for the device. You can generally find this information from the constructors manual or using an oscilloscope.Note it on a piece of paper. | ||
* | * Find the connecting plug for it. Need some magic here. It mostly trying to find the GND first using tester and trying to find the voltage pin and data pin. | ||
* | * Connect you bus pirate to your device. | ||
* | * Find the new device using 'ls /dev/tty*' | ||
* | * Start a shell. Either trough minicom or screen. | ||
* | * m ( for mode) | ||
* | * 3 (for selecting the UART but you can select another mode if you need another protocol) | ||
* | * select your baud rate ( most common baud rate are 9600 or 115200) | ||
* | * default work in most of the case to get your shell on any devices 8 | ||
* | * select stop bits is 1 most of the case | ||
* | * enjoy your shell. | ||
== Real life example == | == Real life example == | ||
