Equipment/HPC LS3060 Laser Cutter/LogBook: Difference between revisions
From London Hackspace Wiki
Equipment/HPC LS3060 Laser Cutter/LogBook (view source)
Revision as of 00:52, 19 January 2011
, 19 January 2011no edit summary
No edit summary |
|||
| Line 1: | Line 1: | ||
__NOTOC__ | __NOTOC__ | ||
==Logbook== | ==Logbook== | ||
===19/1/2011 Note by [[User:Ms7821|Mark]]=== | |||
* The laser cutter <b>will not cut</b> 4mm ply. It won't even scorch the bottom of the wood after 4 passes at speed 3 (and it's hard to tell whether it's cut or not without moving the target). I assume Z axis fiddling is required, but until a decent process is worked out, I've written a warning on the speed chart. | |||
* Enormous difficulty on one pass at speed 5 with 3mm light (balsa) wood. Didn't cut all the way through, and we were again unable to tell whether everything was cut. A large part of the job hardly scratched the wood at all. Recutting this area caused bad singeing in places, so I don't think it's a power issue, but some places/curves still didn't recut. | |||
If we can't work out how to fix the focus/mirrors, can I suggest contacting HPC Laser? | |||
===14/1/2011 Note By [[User:JasperWallace|JasperWallace]]=== | ===14/1/2011 Note By [[User:JasperWallace|JasperWallace]]=== | ||
