53
edits
Equipment/DrillPress: Difference between revisions
From London Hackspace Wiki
m
no edit summary
No edit summary |
mNo edit summary |
||
| Line 6: | Line 6: | ||
|subcat=Fabrication <!-- Sub-category if one exists. Please check main listing to see other categories contained within the main one --> | |subcat=Fabrication <!-- Sub-category if one exists. Please check main listing to see other categories contained within the main one --> | ||
|status=Good working order<!-- Set to one of; Good working order, Faulty, Out of order, Under construction, Out of consumables, Scrapped, or Unknown --> | |status=Good working order<!-- Set to one of; Good working order, Faulty, Out of order, Under construction, Out of consumables, Scrapped, or Unknown --> | ||
|consumables=oil, cutting fluid <!-- Any items used up in normal operation, such as; ink, paper, saw-blades, cutting disks, oil, etc.. --> | |consumables=oil, cutting fluid,drive belt<!-- Any items used up in normal operation, such as; ink, paper, saw-blades, cutting disks, oil, etc.. --> | ||
|accessories=Unknown <!-- Any items associated with the equipment but not consumable, such as; drill bits, safety gloves, goggles, etc.. --> | |accessories=Unknown <!-- Any items associated with the equipment but not consumable, such as; drill bits, safety gloves, goggles, etc.. --> | ||
|reqtraining=No<!-- Is training required to use this equipment? Yes or no. --> | |reqtraining=No<!-- Is training required to use this equipment? Yes or no. --> | ||
| Line 51: | Line 51: | ||
#<artag> it should be a taper. Assuming it's clean (not got anticorrosion varnish on it) then it should want a good fast whack up into the quill. Not with a hammer - just push it fast, by hand. Use the momentmum of the chuck to get it in hard. | #<artag> it should be a taper. Assuming it's clean (not got anticorrosion varnish on it) then it should want a good fast whack up into the quill. Not with a hammer - just push it fast, by hand. Use the momentmum of the chuck to get it in hard. | ||
#<artag> if there's a screw thread in the end of the taper thrn it can use a drawbar like the 3-in-1 but that's fairly unlikely | #<artag> if there's a screw thread in the end of the taper thrn it can use a drawbar like the 3-in-1 but that's fairly unlikely | ||
#<lovelace_> K, seems firmly in now | #<lovelace_> K, seems firmly in now | ||
