Difference between revisions of "Equipment/Britannia Lathe"
Jump to navigation
Jump to search
m |
m |
||
Line 1: | Line 1: | ||
− | + | {{EquipmentInfobox | |
+ | | name = Common name of the item <!-- Name of the item. --> | ||
+ | | image = Hackspace_Unknown.png <!-- Image of the item. Leave with placeholder image if none exists. --> | ||
+ | | model = Unknown <!-- Model --> | ||
+ | | category = Equipment <!-- Main category. Please leave alone to keep item in this category --> | ||
+ | | subcat = Metalworking <!-- Sub-category if one exists. Please check main listing to see other categories contained within the main one --> | ||
+ | | status = Out of order <!-- Set to one of; Good working order, Faulty, Out of order, Under construction, Out of consumables, Scrapped, or Unknown --> | ||
+ | | consumables = Unknown <!-- Any items used up in normal operation, such as; ink, paper, saw-blades, cutting disks, oil, etc.. --> | ||
+ | | accessories = Unknown <!-- Any items associated with the equipment but not consumable, such as; drill bits, safety gloves, goggles, etc.. --> | ||
+ | | reqtraining = Yes <!-- Is training required to use this equipment? Yes or no. --> | ||
+ | | trainlink = Unknown <!-- If training is required, provide a link to training signup or contact page. Otherwise leave blank. --> | ||
+ | | acnode = <!-- Is the equipment ACnode locked? --> | ||
+ | | owner = Unknown <!-- Provide a link to owners members page if other than LHS --> | ||
+ | | origin = Donation<!-- If via pledge, please link to the completed pledge page on the wiki --> | ||
+ | | location = <!-- Floor, room/zone and location within that area --> | ||
+ | | maintainers = <!-- NO LINKS PLEASE; it currently breaks the template. If someone is nominated as managing the upkeep of this item, please list them here. --> | ||
+ | | template_ver = 1.1 <!-- Please do not change. Used for tracking out-of-date templates --> | ||
+ | }} | ||
== Britannia lathe renovation == | == Britannia lathe renovation == | ||
Line 5: | Line 22: | ||
There is a potential 12VDC in my box, will need to make a speed controller for it. Alternatively just use a normal mains motor with a step pully as the lathe was designed for. 3 phase motors with inverter speed controllers start to look expensive. | There is a potential 12VDC in my box, will need to make a speed controller for it. Alternatively just use a normal mains motor with a step pully as the lathe was designed for. 3 phase motors with inverter speed controllers start to look expensive. | ||
− | |||
− |
Revision as of 15:46, 29 May 2013
Common name of the item | |
---|---|
![]() | |
Model | Unknown |
Sub-category | Metalworking |
Status | Out of order |
Consumables | Unknown |
Accessories | Unknown |
Training requirement | Yes |
Training link | Unknown |
Owner | Unknown |
Origin | Donation |
Britannia lathe renovation
27/5/2013 Removed tool board from back board. it's stored under/behind the lathe cabinet. Cut bit of wood for the motor to sit on. it's sitting in place for now with a sign not to remove. Will fasten it in place permanently when final motor decision is made.
There is a potential 12VDC in my box, will need to make a speed controller for it. Alternatively just use a normal mains motor with a step pully as the lathe was designed for. 3 phase motors with inverter speed controllers start to look expensive.