Project:BinaryClock

What

An extension of the binary clock that Ciarán made after the Arduino Workshop.

Design Criteria

• Must have a nice case.
• Must have a time display (duh).
• Must have a minimum of buttons, preferably two
• Will use GPS time/date to be semi-accurate.
• Must be able to change between GMT/BST
• Must be as low power, long life as possible.
  • By default time display will be off.

Non-essentials

• Nice to have a external output, ie when alarm goes off a pin goes high. So alarm can be hacked to trigger other events.

How

Logic

Button Logic

Buttons need to snooze, set alarm, show date, show time, show alarm.

The following is based on two buttons

• Either button will snooze the alarm, if alarm is sounding.
• Holding button 1 will turn alarm off.
• Button 1 will show time (when no time or date is displayed).
• Button 2 will show date.
• Holding button 2 will show alarm.
• Holding Button 1+2 will put clock into set alarm mode.
  • Button 1 will increase the hour, button 2 will set the hour.
  • Button 1 will increase minute, button 2 will set the minute.
  • Clock will go back to displaying the time.

Code

Get it here! - Note: There is no code yet, really.

Hardware

Laser cutter designs for enclosure.

TODO

• Get accurate time measurement
• Add buttons
• Add ability to set an alarm
• Add a piezo
• Make battery supply
• Make it "radio-controlled"
• Make a box

Task	Date Completed
Prototype Display
Display PCB
Prototype Buttons
PCB Buttons
Prototype Alarm
PCB Alarm
Prototype Time
PCB Time
Prototype Combined Clock
PCB Combined Clock

Circuit

Phase 1

Designed PCB for shift registers, and LEDs. This board will become the "Display"