Equipment/Prologix GPIB-USB controller: Difference between revisions
From London Hackspace Wiki
No edit summary |
No edit summary |
||
| Line 1: | Line 1: | ||
There is a Prologic GPIB to Ethernet adaptor available in the electronics area. It connects a couple of meters to ethernet - and lets one do some automation on capture. | There is a Prologic GPIB to Ethernet adaptor available in the electronics area. It connects a couple of meters to ethernet - and lets one do some automation on capture. | ||
| Line 18: | Line 16: | ||
I.e. telnet to the box, talk to GPIB address 10 - ask it to identify itself - and then proceed to measure the voltage (this will by default assume autoranging and adjust the settings as needed). | I.e. telnet to the box, talk to GPIB address 10 - ask it to identify itself - and then proceed to measure the voltage (this will by default assume autoranging and adjust the settings as needed). | ||
This device is *not* to hack - just to aid your hacking :) | |||
Revision as of 23:19, 3 April 2011
There is a Prologic GPIB to Ethernet adaptor available in the electronics area. It connects a couple of meters to ethernet - and lets one do some automation on capture.
- MAC Address: 00:21:69:01:05:57 a
- Usually on IP Address 172.31.24.126
- [Documentation]
- Responds to 3040 discovery and telnet to port 1234
Typical use session:
- telnet 172.31.24.126 1234
- ++addr 10
- *IDN?
- HP127812
- MEASURE:VOLT:DC
- 12.3912
I.e. telnet to the box, talk to GPIB address 10 - ask it to identify itself - and then proceed to measure the voltage (this will by default assume autoranging and adjust the settings as needed).
This device is *not* to hack - just to aid your hacking :)
