Equipment/DrillPress: Difference between revisions
From London Hackspace Wiki
No edit summary |
|||
Line 33: | Line 33: | ||
#<Randomskk> that's what she said | #<Randomskk> that's what she said | ||
[[Category: | [[Category:Tools for use on wood]][[Category:Tools for use on metal]] |
Revision as of 09:35, 29 April 2013
Status
We now have a drill press. The keyless chuck only goes down to 2.7 mm, so we need to get a "pin chuck". Russsss found one at the Crystal Palace workshop apparently, but I don't know where it is.
Or you can use the Dremel and mini-mill for high speed / light duty / precision stuff, and this one for everything else.
Ideal jobs :
Dremel
- High speed, tiny bits e.g. PCB drilling
Mini-Mill
- Milling plastic, small aluminium etc.
- Drilling jobs requiring accurate positioning - use the table positioning
Drill Press
- Most general purpose drilling jobs
Model
- Make: Axminster
- Model: ED16SB
- Manual: on the Axminster website
Log
- <lovelace_> The chuck for the new stand drill falls out easily
- <lovelace_> I can't see how it tightens up
- <artag> it should be a taper. Assuming it's clean (not got anticorrosion varnish on it) then it should want a good fast whack up into the quill. Not with a hammer - just push it fast, by hand. Use the momentmum of the chuck to get it in hard.
- <artag> if there's a screw thread in the end of the taper thrn it can use a drawbar like the 3-in-1 but that's fairly unlikely
- <creature> Your mum enjoys a good fast whack up into the quill.
- <lovelace_> K, seems firmly in now
- <Randomskk> that's what she said