Project:Cigar Box Guitars
How
Based on these Make Magazine projects. Guitar and Amp
Parts
Guitar
Part | Quantitiy | Notes |
Cigar box | 4 | |
1×2 oak or maple lumber | 0 | 3' length The actual dimensions are 3/4"×1 1/2". A 6' stick, enough for 2 necks, Pick the straightest, flattest, clearest, meaning free of knotholes, piece you can find. |
Guitar strings | 0 | Standard medium-gauge strings work well. CBGs typically use open G tuning. I use strings 5, 4, and 3 and tune them to G-D-G. |
Tuning pegs | 6 | 1 Pack of six individual heads |
Fret wire | 9feet | Figuring 2inch width on neck, 24 frets, 2 guitars plus a bit extra |
Cabinet hinge | 0 | with 3 mounting holes on each side |
1" wood screws Phillips head | 0 | |
Bamboo barbecue skewer or other hard, thin rod | 0 | for the bridge and nut |
Super glue optional | 0 |
Amp
Part | Quantitiy | Notes |
Toggle switch, SPST single pole single throw | Bit box at space? | |
9V battery | ||
Battery connector | Plenty at the space | |
0.047µF capacitor | Bit box at the space? | |
220µF capacitor biggest | Bit box at the space? | |
0.01µf capacitor | Bit box at the space? | |
100µf capacitor | Bit box at the space? | |
10Ω resistor | Bit box at the space? | |
Hookup wire 20 or 22 gauge solid core is best | Bit box at the space? | |
5KW potentiometer, audio or log taper | Bit box at the space? | |
25-ohm 25W rheostat | Bit box at the space? | |
LM386N audio amplifier chip | 2 | |
8-pin DIP IC socket | ||
1/4" mono phone jack | Plenty at the space | |
Chicken head knobs (2) | Bit box at the space? | |
Prototyping PC board | Plenty at the space | |
Speaker, 8Ω impedance | Bit box at the space? | |
Speaker grill optional |
Progress
Notes
Who
Ciarán and Nick are the main instigators but others a welcome to join in!