Ajax Pillar Drill
| Pillar Drill (Ajax) | |
|---|---|
 | |
| Model | Unknown |
| Sub-category | Woodworking |
| Status | Good working order |
| Last updated | 13 August 2024 21:05:09 |
| Training requirement | no |
| ACnode | no |
| Location | Wood shop |
| Maintainers | Woodshop team |
A benchtop pillar drill for all kinds of wood drilling
No training requirement, but please seek advice from other woodshop users if you are unfamiliar with its use
Always remove drill bits from the chuck and sweep away chips after use
Generally for use on wood only, there are other pillar drills available in the metalworking shop for use on metal. Metal drilling sends small chips flying everywhere which can cause havoc when they eventually come into contact with delicate wooden projects, so please keep them separate
Risk Assessment - Pillar Drills
This risk assessment is intended to provide guidance on the risk associated with the above equipment and activities in normal use. Please also check general risk assessments for the space as a whole. Any discrepancies, errors or concerns should be raised with the document maintainers or trustees - do not edit this assessment directly. For responsible persons and last update, see 'version log' of the assessment page.
Activity
Cutting metal or suitable plastics on the metal mill
Signage
Understanding Risk Rating
LOW - Ensure current control measures are in place and continue with activity
MED - Control measures may be adequate, co-supervision is recommended
HIGH - Do not undertake activity without further consultation with area specialists
Risk Assessment
| Identify Hazards | Who May be Harmed and How | Severity | Control Measures | Likelihood | Risk Rating |
|---|---|---|---|---|---|
| Incompetent user | User, Bystander | HIGH | Users must not use tools that they are not competent to use. Members must challenge use that they believe is dangerous. Users must read the user manual where applicable. Users must read the risk assessment before using a tool. | LOW | MED |
| Contact With Drill Bit | User – serious harm | HIGH | Only make adjustments to the pillar drill when the machine is switched off. Ensure chuck is tight before switching drill on. Ensure drill guard is in place before switching drill on. Do not put hands into exclusion zone (within 10cm of drill bit). Do not leave pillar drill running when not in use. | LOW | MED |
