Difference between revisions of "Equipment/OldVinylCutter"
| Line 14: | Line 14: | ||
|origin=Long term loan from Hipster<!-- If via pledge, please link to the completed pledge page on the wiki --> | |origin=Long term loan from Hipster<!-- If via pledge, please link to the completed pledge page on the wiki --> | ||
|location=<!-- Floor, room/zone and location within that area --> | |location=<!-- Floor, room/zone and location within that area --> | ||
| − | |maintainers=Hipster <!-- NO LINKS PLEASE; it currently breaks the template. If someone is nominated as managing the upkeep of this item, please list them here. --> | + | |maintainers=Hipster, Velyks, Det <!-- NO LINKS PLEASE; it currently breaks the template. If someone is nominated as managing the upkeep of this item, please list them here. --> |
|template_ver=1.1 <!-- Please do not change. Used for tracking out-of-date templates --> | |template_ver=1.1 <!-- Please do not change. Used for tracking out-of-date templates --> | ||
}} | }} | ||
| − | |||
Revision as of 16:47, 8 December 2014
| Vinyl cutter | |
|---|---|
 | |
| Model | Unknown |
| Sub-category | Office equipment |
| Status | Good working order |
| Consumables | Unknown |
| Accessories | Unknown |
| Training requirement | Yes |
| Training link | Vinylcutter_Training |
| Owner | Hipster |
| Origin | Long term loan from Hipster |
| Maintainers | Hipster, Velyks, Det |
Training
TRAINING NEEDED BEFORE USE
Training is run by Velyks on Fridays, notices of training sessions will be put on the mailing list. Training schedule can be found here
Data
- Max. Cutting Width: 610mm
- Cutting Speed: 10-800mm/s
- Cutting Force: 10g-500g
- Page with more info
- Setup info
Software
The Windows and Linux drivers are on the Whittenstein usb card that is attached to the machine.
We've currently been unable to get the FTDI Virtual Com Port drivers working with the cutter under OSX Mavericks. If you have success with OSX, please update this page.
Linux Instructions:
Download Inkscape, move items in the driver folder from USB card into: /home/.config/inkscape/extensions
Run inkscape and should be there under extensions, cutter/plotter.
Usage
The vinyl cutter will happily take HPGL piped over serial, eg in Linux:
cat filename.hpgl > /dev/ttyUSB0
Make sure you have write permissions for the ttyUSB0 device, a quick temporary hack for this is: sudo chmod 0777 /dev/ttyUSB0
Note: If you have multiple USB serial devices, the cutter may not be ttyUSB0
What you use to make the HPGL is up to personal preference. Inkscape can export as HPGL, and has plugins for both Linux/OSX (InkCut) and Windows (Inkscape CAMM-GL) to help fine tune cuts.
Note: Inkscape 4.9+ generates large HPGL with all the coordinates as a single line. This buffer overflows the black vinyl cutter causing it to crash.
Smaller designs may be fine, otherwise manually add a carriage return after each instruction by using a text editor.
Protip in vi:
:s/;/;\r/g
T-Shirts
You can heat press designs onto t-shirts using the heat press
Consumables
Put something here about appropriate types, thickness, etc.
Suppliers:
Old Vinyl Cutter
The old cutter is in the space but is not functional Equipment/VinylCutterOld