Difference between revisions of "Project:Oyster Card Hacking"
| (2 intermediate revisions by the same user not shown) | |||
| Line 16: | Line 16: | ||
* Repeat until chip is visible. | * Repeat until chip is visible. | ||
| − | The wire for the antenna of the chip is very fine so it's easier and quicker to extract the chip without it and opt to solder on your own antenna. The contacts on the chip are quite weak so care has to be taken not to break them off | + | The wire for the antenna of the chip is very fine so it's easier and quicker to extract the chip without it and opt to solder on your own antenna. The contacts on the chip are also quite weak so care has to be taken not to break them off. The contacts look like wings on either side of the chip and should be easy to spot if you look at where the aerial connects to the chip. Encasing the chip in something like hot glue will help prevent the antenna detaching. For what it's worth, the aerial in the card is about 13cm long with 5 loops but you may need to experiment a little to make a working replica. |
== Gallery == | == Gallery == | ||
| Line 26: | Line 26: | ||
File:Oyster_card_chip_ready_for_use.JPG|Oyster card chip extracted and ready to use. | File:Oyster_card_chip_ready_for_use.JPG|Oyster card chip extracted and ready to use. | ||
</gallery> | </gallery> | ||
| + | |||
| + | |||
| + | [[Category:Projects]] | ||
Latest revision as of 14:34, 30 May 2013
| Oyster Card Hacking | |
|---|---|
| Created | 20/03/2011 |
| Members | Montyphy |
| QR code | |
Description
Extracting the chip from an Oyster card.
Components
- Oyster card
- Acetone (commonly found in nail polish remover)
Process
- Submerge card in acetone until it softens.
- Peel off layer of plastic and submerge again.
- Repeat until chip is visible.
The wire for the antenna of the chip is very fine so it's easier and quicker to extract the chip without it and opt to solder on your own antenna. The contacts on the chip are also quite weak so care has to be taken not to break them off. The contacts look like wings on either side of the chip and should be easy to spot if you look at where the aerial connects to the chip. Encasing the chip in something like hot glue will help prevent the antenna detaching. For what it's worth, the aerial in the card is about 13cm long with 5 loops but you may need to experiment a little to make a working replica.
Gallery
Beginning the process of peeling off the plastic layers after having submerged the card in acetone for a few hours.
A naked Oyster card.
A naked Oyster card in acetone to further soften it up.
Oyster card chip extracted, soldered with new antenna and encased in hot glue.
Oyster card chip extracted and ready to use.
