Difference between revisions of "Stationary Dust Extractor"
Jump to navigation
Jump to search
(Page Creation) |
(Image Added) |
||
| Line 1: | Line 1: | ||
{{EquipmentInfobox | {{EquipmentInfobox | ||
|name=Stationary Dust Extractor | |name=Stationary Dust Extractor | ||
| − | |image= | + | |image=Workshop Dust Extractor.jpg |
|model=Unknown | |model=Unknown | ||
|category=Equipment | |category=Equipment | ||
Revision as of 08:26, 24 February 2022
| Stationary Dust Extractor | |
|---|---|
 | |
| Model | Unknown |
| Sub-category | Woodworking |
| Status | Good working order |
| Last updated | 8 August 2022 17:08:08 |
| Training requirement | no |
| ACnode | no |
| Location | Wood shop |
| Maintainers | Woodshop team |
The stationary dust extractor is located in the corner of the woodshop nearest to the door and is connected by ducting to many of the dusty machines in the woodshop. It is turned on and off by a green and red switch located just behind the extractor - please turn it on before using any of the connected machines e.g. planer, table saw. Remember to switch off when you are done using the equipment to save power.
For machines not connected to this extractor the Portable extractor can be used.
Collected dust is stored in the blue drum under the unit which must be emptied periodically.
Note - there are no obvious external markings as to the make/ model of this unit, hopefully that information can be found inside as and when needed