Equipment/DrillPress: Difference between revisions
From London Hackspace Wiki
add info about chuck
(→Status) |
(add info about chuck) |
||
| Line 22: | Line 22: | ||
* Model: [http://www.axminster.co.uk/axminster-axminster-ed16sb-pillar-drill-prod719342/ ED16SB] | * Model: [http://www.axminster.co.uk/axminster-axminster-ed16sb-pillar-drill-prod719342/ ED16SB] | ||
* Manual: [http://www.axminster.co.uk/downloads/700101_manual.pdf on the Axminster website] | * Manual: [http://www.axminster.co.uk/downloads/700101_manual.pdf on the Axminster website] | ||
==Log== | |||
<lovelace_> The chuck for the new stand drill falls out easily | |||
<lovelace_> I can't see how it tightens up | |||
<artag> it should be a taper. Assuming it's clean (not got anticorrosion varnish on it) then it should want a good fast whack up into the quill. Not with a hammer - just push it fast, by hand. Use the momentmum of the chuck to get it in hard. | |||
<artag> if there's a screw thread in the end of the taper thrn it can use a drawbar like the 3-in-1 but that's fairly unlikely | |||
<creature> Your mum enjoys a good fast whack up into the quill. | |||
<lovelace_> K, seems firmly in now | |||
<Randomskk> that's what she said | |||
