1,581
edits
Equipment/High Vacuum Station: Difference between revisions
From London Hackspace Wiki
Equipment/High Vacuum Station (view source)
Revision as of 16:16, 24 September 2011
, 24 September 2011→Needs
(→Needs) |
|||
| Line 83: | Line 83: | ||
*Water pump (for cooling loop). | *Water pump (for cooling loop). | ||
*1" thick aluminium or stainless plate, at least 7 1/4" diameter. | *1" thick aluminium or stainless plate, at least 7 1/4" diameter. | ||
**I have a block of aluminium 250mm sq x 75 mm. a bit wasteful but could be used. artag. | |||
*Clean box section or angle-iron (a push-fit connector frame would be fine too). | *Clean box section or angle-iron (a push-fit connector frame would be fine too). | ||
*1.5-2" thick, ~4" wide sturdy plastic (delrin?) to turn an large threaded fitting for the chamber. | *1.5-2" thick, ~4" wide sturdy plastic (delrin?) to turn an large threaded fitting for the chamber. | ||
**I have a 100m dia, 45mm thick lump of nylon and a fair bit of 50mm delrin if it's any use. artag. | |||
*20mm+ thick polycarbonate sheet (will probably order cut to size). | *20mm+ thick polycarbonate sheet (will probably order cut to size). | ||
*Small metal or plastic pressure vessel with removable end (to act as | *Small metal or plastic pressure vessel with removable end (to act as | ||
