1,574
edits
Equipment/Stratasys FDM 1650: Difference between revisions
From London Hackspace Wiki
→Current Status - 6/10/11
(→TODO) |
|||
| Line 60: | Line 60: | ||
* Using [http://www.nordson.com/en-us/divisions/asymtek/documents/manuals/76_cs02_01_acl_manual.pdf the acl docs], find the current values of the personality parameters, document them here. This will hopefully keep us from loosing them by accident later, and tell us a bit about how the machine is set up. You'll want the OP command, page 3-50, and the list of personality parameters, page 14-1. | * Using [http://www.nordson.com/en-us/divisions/asymtek/documents/manuals/76_cs02_01_acl_manual.pdf the acl docs], find the current values of the personality parameters, document them here. This will hopefully keep us from loosing them by accident later, and tell us a bit about how the machine is set up. You'll want the OP command, page 3-50, and the list of personality parameters, page 14-1. | ||
DONE! [[Equipment:Stratasys_FDM_1650#Initial_Conditions]] | DONE! [[Equipment:Stratasys_FDM_1650#Initial_Conditions]] | ||
==Current Status - 17/10/11== | |||
*Moved out of alcove and tried a few basic things. | |||
*Self-test ran (aborted) after restoring front panel connector. | |||
*All axes capable of movement using arrow pad. | |||
*Remaining parameters dumped and entered in wiki | |||
*Feed Home command works | |||
*Z home using buttons appears not to stop (aborted, looked dangerous) | |||
*ACL manual reports that microstepping is used (but is that for a different controller ?) | |||
==Current Status - 6/10/11== | ==Current Status - 6/10/11== | ||
