162
edits
Project:Cupcake-o-Matic: Difference between revisions
From London Hackspace Wiki
→A Better Extruder
No edit summary |
|||
| Line 28: | Line 28: | ||
[[File:Gregs_Extruder_mounted_in_cupcake.jpg|thumb|150px|The Gregs extruder setup.]] | [[File:Gregs_Extruder_mounted_in_cupcake.jpg|thumb|150px|The Gregs extruder setup.]] | ||
===A Better Extruder=== | ===A Better Extruder=== | ||
The Makerbot Cupcake CNCs from batch 6 came with a laser cut [http://wiki.makerbot.com/plastruder-mk4 Plastruder MK4] | The Makerbot Cupcake CNCs from batch 6 came with a laser cut [http://wiki.makerbot.com/plastruder-mk4 Plastruder MK4]. To drive the filament a T2.5 timing belt gear was used, it had 17 teeth which would bite into the filament, however the teeth were blunt so could not get a good grip on the filament reliably. This lead to the extruder jamming mid way through a print. When the Plastruder MK4 came out it was a new design but it was quickly superseded by improvements from the RepRap project. | ||
Replaced the MK4 Plastruder with a Gregs Modified Wade Extruder | These improvements took the form of the Wades extruder, a simplified version of the Bowyer extruder. The Wades extrider is notable for it's use of a single mounting block, a stepper motor, two gears and an idler assembly. | ||
Replaced the nichrome wire on the hot end with a heater block and power resistor. | |||
Replaced the MK4 Plastruder with a Gregs Modified Wade Extruder. Replaced the nichrome wire on the hot end with a heater block and power resistor. | |||
<br style="clear: both" /> | <br style="clear: both" /> | ||
