162
edits
Project:Cupcake-o-Matic: Difference between revisions
From London Hackspace Wiki
no edit summary
No edit summary |
|||
| Line 39: | Line 39: | ||
Replaced the 300W PC power supply with a 12V 30A Power supply (may be further replaces with a smaller PSU) | Replaced the 300W PC power supply with a 12V 30A Power supply (may be further replaces with a smaller PSU) | ||
===A Better Extruder=== | |||
[[File:Gregs_Extruder_mounted_in_cupcake.jpg|thumb|250px|The Gregs extruder setup.]] | [[File:Gregs_Extruder_mounted_in_cupcake.jpg|thumb|250px|The Gregs extruder setup.]] | ||
The Makerbot Cupcake CNCs from batch 6 came with a laser cut [http://wiki.makerbot.com/plastruder-mk4 Plastruder MK4]. To drive the filament a T2.5 timing belt gear was used, it had 17 teeth which would bite into the filament, however the teeth were blunt so could not get a good grip on the filament reliably. This lead to the extruder jamming mid way through a print. When the Plastruder MK4 came out it was a new design but it was quickly superseded by improvements from the RepRap project. | The Makerbot Cupcake CNCs from batch 6 came with a laser cut [http://wiki.makerbot.com/plastruder-mk4 Plastruder MK4]. To drive the filament a T2.5 timing belt gear was used, it had 17 teeth which would bite into the filament, however the teeth were blunt so could not get a good grip on the filament reliably. This lead to the extruder jamming mid way through a print. When the Plastruder MK4 came out it was a new design but it was quickly superseded by improvements from the RepRap project. | ||
