146
edits
Laser Cutter/Parameters: Difference between revisions
From London Hackspace Wiki
Changed to make it more general than just MDF
(→MDF: Do not cut 6 mm MDF) |
(Changed to make it more general than just MDF) |
||
| Line 1: | Line 1: | ||
If you found some sweet settings please share them here. | If you found some sweet settings please share them here. | ||
==Background== | ==Background== | ||
===Thick Material=== | |||
Do not try to cut anything thicker than the thickest width listed for that material on this page. | |||
===Corner Power=== | ===Corner Power=== | ||
When the path goes round curves, or a straight line passes close to previous line (TBC), the laser will slow down. As a consequence, the Corner Power needs to be lower to compensate. Typically about 80% of the Power setting. | When the path goes round curves, or a straight line passes close to previous line (TBC), the laser will slow down. As a consequence, the Corner Power needs to be lower to compensate. Typically about 80% of the Power setting. | ||
| Line 101: | Line 103: | ||
| | | | ||
|} | |} | ||
====Misc==== | ====Misc==== | ||
