146
edits
Laser Cutter/Parameters: Difference between revisions
From London Hackspace Wiki
→Background: Added lowest power.
(Changed to make it more general than just MDF) |
(→Background: Added lowest power.) |
||
| Line 5: | Line 5: | ||
===Corner Power=== | ===Corner Power=== | ||
When the path goes round curves, or a straight line passes close to previous line (TBC), the laser will slow down. As a consequence, the Corner Power needs to be lower to compensate. Typically about 80% of the Power setting. | When the path goes round curves, or a straight line passes close to previous line (TBC), the laser will slow down. As a consequence, the Corner Power needs to be lower to compensate. Typically about 80% of the Power setting. | ||
===Lowest power=== | |||
Setting the power below 10 or 11 means that the laser will not activate. | |||
===Tried but DIY parameters=== | ===Tried but DIY parameters=== | ||
Laser rubber has been used (mainly for stamps) it works well but you'll need to experiment for engraving/cutting | |||
==Parameters== | ==Parameters== | ||
