Project:Aerostruder: Difference between revisions
From London Hackspace Wiki
(It's done and fitted to Crump.) |
|||
| Line 19: | Line 19: | ||
* Extruder assembly mounted | * Extruder assembly mounted | ||
* Limit switch mounted | * Limit switch mounted | ||
* wiring harness finished | |||
* Electrical testing | |||
* Fitting and alignments, change slicing profiles or E-Steps setting in Marlin firmware if necessary | |||
== | == Issues == | ||
When doing long extrudes (manually pressing the extrude button with more than 50mm extruded), it has a habit of grinding the filament, which does not occur during regular printing. The cause of this is not yet determined. | |||
== | == To Do == | ||
* | * Octoprint / Cura slicing profile for Ninjaflex | ||
Revision as of 14:44, 27 January 2020
| Aerostruder | |
|---|---|
| Created | 21/07/2020 |
| Members | Welshie,
Thomas Greer, Michael Cullen, Mike Chislett, |
| QR code | |
To build and fit an E3D aerostruder hotend to one, or both of the Lulzbot Minis. The Aerostruder setup will allow printing with flexible filaments as well as rigid.
Progress
- 3D printed parts created
- Brass inserts applied
- Extruder motor mounted
- Extruder assembly mounted
- Limit switch mounted
- wiring harness finished
- Electrical testing
- Fitting and alignments, change slicing profiles or E-Steps setting in Marlin firmware if necessary
Issues
When doing long extrudes (manually pressing the extrude button with more than 50mm extruded), it has a habit of grinding the filament, which does not occur during regular printing. The cause of this is not yet determined.
To Do
- Octoprint / Cura slicing profile for Ninjaflex
